Replacing Seal Between Toilet Tank Bowl

Replacing Seal Between Toilet Tank Bowl. Btw, if you ever replace the fluidmaster fill valve that came with the koehler, be careful that the new fill tube (white in the original) is not of a narrower od, or else. Is your toilet leaking between the tank and the bowl after flushing?

American Standard Champion Close Coupled Kit-738756-0070AP ... from images.homedepot-static.com

Replace the wax ring under the toilet, making sure it is thick enough to form a seal and the bolts are installed correctly and holding the toilet down. If either the toilet tank or bowl are cracked, replace the entire toilet. For information on how to do this, see how to install a toilet.

Simply use a long screwdriver to hold them in the tank and then loosen them from the underside.

Next, disconnect the tank to bowl nuts on the tank. Most of this video will demonstrate how to replace the wax ring, a critical part of replacing the toilet. Since there is no longer a tight seal, the water constantly leaks from tank to bowl. Doing so will make it easier to align.

Ask for a toilet to tank seal and washers for the bolts which might come with the large seal(check) 1.

There is a rubber seal which is situated between to tank and bowl which may have failed and needs replacing.

Replace the wax ring under the toilet, making sure it is thick enough to form a seal and the bolts are installed correctly and holding the toilet down.

When you flush the toilet water leaves the tank and goes down into the bowl.

Remove the caulk with a putty knife.

If you did the colored water test and noticed if this is the case with your line, it would be best to replace the washer.

Secure the bolt and apply caulk to seal the base.

The toilet bowl itself seals with a wax.

Place a bucket underneath your toilet tank to catch any excess water.

Location:

Share :